Wednesday, June 12, 2019

2019 Cadillac Truck Escalade AWD V8-6.2L Diagnostic Instructions Page 622


Steering Wheel Schematics (See: Diagrams/Electrical Diagrams/Steering/Steering Column/Steering Wheel Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Steering Wheel and Column Description and Operation (See: Steering and Suspension/Steering/Steering Column/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for Scan Tool Information



Circuit/System Verification



Ignition ON, command the tilt motor UP and DOWN with a scan tool. The reading should be between 0.2 and 4.8 volts.



Circuit/System Testing



Tilt Sensor Circuit Malfunction



1. Ignition OFF, disconnect the harness connector at the tilt actuator.



2. Ignition OFF, test for less than 10.0 ohms between the low reference circuit terminal E and ground.



锟斤拷 If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the MSM.



3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal D and ground.



锟斤拷 If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,



replace the MSM.



锟斤拷 If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the MSM.



4. Verify the scan tool Tilt Sensor parameter is less than 0.2 volt.



锟斤拷 If greater than the specified range, test the signal circuit terminal C for a short to voltage. If the circuit tests normal, replace the MSM.



5. Install a 3A fused jumper wire between the signal circuit terminal C and the 5-volt reference circuit terminal D. Verify the scan tool Tilt



Sensor parameter is greater than 4.8 volts.



锟斤拷 If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the



MSM.



6. Install a test lamp between the control circuit terminal A and the control circuit terminal B.



7. Command the column to tilt up and down using the tilt switch. The test lamp should illuminate with each command.



锟斤拷 If the test lamp does not illuminate, test both control circuits for a short to ground or an open/high resistance. If the circuits test normal,



replace the MSM.



8. If all circuits test normal, test or replace the tilt actuator.



Component Testing



Tilt Actuator



1. Ignition OFF, disconnect the harness connector at the tilt actuator.



2. Test for less than 2.0 ohms between the control terminal A and the control terminal B.



锟斤拷 If greater than the specified range, replace the tilt actuator.

No comments:

Post a Comment