Tuesday, August 6, 2019

2019 Cadillac Truck Escalade AWD V8-6.2L Diagnostic Instructions Page 585


Circuit/System Description



Voltage is applied at all times to the park lamp relay from battery voltage. When the headlamp switch is placed in the PARK position and the body



control module (BCM) commands the park lamps ON, the BCM then applies a ground to the park lamp relay control circuit. This engages the relay



and applies voltage through the park lamp fuses and to all the park, license, and tail lamps.



Conditions for Running the DTC



* The Ignition is ON.



* The park lamps must be commanded ON by the BCM.



Conditions for Setting the DTC



The BCM detects a short to voltage on the park lamp relay control circuit.



Action Taken When the DTC Sets



All park, license, and tail lamps are inoperative.



Conditions for Clearing the DTC



* The conditions for setting the DTC are no longer present.



* A history DTC clears after 100 malfunction-free ignition cycles.



* The BCM receives the clear code command from the scan tool.



Reference Information



Schematic Reference



Exterior Lights Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Exterior Lights Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems Description



and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



1. Ignition OFF, disconnect the park lamp relay.



2. Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 87 and ground.



锟斤拷 If the test lamp illuminates, test the control circuit for a short to voltage.

No comments:

Post a Comment