Friday, August 2, 2019

2019 Cadillac Truck Escalade AWD V8-6.2L Diagnostic Instructions Page 528


(MSM) and the temperature of the seat surface determines the signal circuit voltage. Once the seat reaches the set temperature, the module will then



cycle the control circuits of the heating elements ON and OFF in order to maintain the desired seat temperature based on the feedback voltage from



the sensors.



Conditions for Running the DTC



The heated seat system must be active.



Conditions for Setting the DTC



B2435 02 or B2440 02



The temperature sensor voltage drops below 0.8 volt for more than 1 second.



B2435 05 or B2440 05



The temperature sensor voltage is greater than 5 V for more than 1 second.



Action Taken When the DTC Sets



The heated seat function for the appropriate seat will be disabled.



Conditions for Clearing the DTC



* The current DTC will clear 3 seconds after the reference voltage returns to normal operating range, and the ignition is cycled OFF then back to



ACC or RUN.



* A history DTC will clear after 50 ignition cycles or with a scan tool using the clear DTCs function.



Reference Information



Schematic Reference



Heated/Cooled Seat Schematics ()



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Heated Seats Description and Operation (KA1) ()Heated Seats Description and Operation (KA6) ()



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Verify the type of vehicle and the heated seat system for which the DTC set.



If the DTC set in a vehicle equipped with memory, refer to Circuit/System Testing below.



If the DTC set in a hybrid or a non-hybrid vehicle without memory, refer to DTC B2435 or B2440 (HP2 or dealer installed w/o memory).



Circuit/System Testing



B2435 02 or B2435 05



1. Ignition OFF, disconnect the X2, X5 harness connectors at the MSM.



2. Test for 850 Ohms - 300 kOhms between the signal circuit terminal 4 X5 and the low reference circuit terminal 2 X2.



锟斤拷 If less than the specified range, test for a short between the signal and low reference circuits. If the circuits test normal, replace the seat



back heater element/temperature sensor.



锟斤拷 If greater than the specified range, test the signal and low reference circuits for a short to voltage or an open/high resistance. If the circuits



test normal, replace the seat back heater element/temperature sensor.

No comments:

Post a Comment