Sunday, August 25, 2019

2019 Cadillac Truck Escalade AWD V8-6.2L Diagnostic Instructions Page 664


* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Ignition ON, observe the scan tool Pedal Forward Switch and Pedal Aft Switch parameters while cycling the adjustable pedal switch between the



FWD and RWD position. The appropriate parameter should change between Active and Inactive as commanded.



Circuit/System Testing



1. Disconnect the harness connector at the adjustable pedal switch.



2. Ignition ON, test for 11.8-12.2 volts between the appropriate 12-volt reference circuit listed below and ground:



* X88/Z88 - terminal 11



* Z75 - terminal 5



锟斤拷 If greater than the specified range, test the 12-volt reference circuit for a short to voltage. If the circuit tests normal, replace the MSM.



锟斤拷 If less than the specified range, test the 12-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,



replace the MSM.



3. Verify the scan tool Pedal Forward Switch parameter is Inactive.



锟斤拷 If not the specified value, test the appropriate signal circuit terminal listed below for a short to voltage. If the circuit tests normal, replace



the MSM.



* X88/Z88 - terminal 12



* Z75 - terminal 6



4. Verify the scan tool Pedal Aft Switch parameter is Inactive.



锟斤拷 If not the specified value, test the appropriate signal circuit terminal listed below for a short to voltage. If the circuit tests normal, replace



the MSM.



* X88/Z88 - terminal 10



* Z75 - terminal 4



5. Install a 3A fused jumper wire between the appropriate signal circuit terminal listed below and B+. The scan tool Pedal Forward Switch



parameter should be Active.



* X88/Z88 - terminal 12



* Z75 - terminal 6



锟斤拷 If not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the



MSM.



6. Install a 3A fused jumper wire between the appropriate signal circuit terminal listed below and B+. The scan tool Pedal Aft Switch parameter



should be Active.



* X88/Z88 - terminal 10



* Z75 - terminal 4



锟斤拷 If not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the



MSM.



7. If all circuits test normal, test or replace the adjustable pedal switch.

No comments:

Post a Comment