Friday, October 4, 2019

2019 Cadillac Truck Escalade AWD V8-6.2L Diagnostic Instructions Page 444


Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for Scan Tool Information



Circuit/System Verification



Ignition ON, observe all scan tool Driver Position Module seat switch parameters while pressing and releasing the each seat directional switch. The



reading should change between Inactive and Active.



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector at the seat adjuster switch.



2. Verify the scan tool seat switch parameters listed below are Inactive.



* Front Vertical Upward Switch



* Front Vertical Downward Switch



* Rear Vertical Upward Switch



* Rear Vertical Downward Switch



* Horizontal Forward Switch



* Horizontal Rearward Switch



* Recline Forward Switch



* Recline Rearward Switch



锟斤拷 If not the specified value, test the appropriate signal circuit listed below for a short to voltage. If the circuit tests normal, replace the MSM.



* Front vertical upward switch terminal A



* Front vertical downward switch terminal K



* Rear vertical upward switch terminal F



* Rear vertical downward switch terminal J



* Horizontal forward switch terminal D



* Horizontal rearward switch terminal C



* Recline forward switch terminal H



* Recline rearward switch terminal G



3. If all circuits test normal, test or replace the seat adjuster switch.



Component Testing



1. Ignition OFF, disconnect the harness connector at the seat adjuster switch.



2. Test for infinite resistance between each seat direction signal terminal listed below and the B+ terminal E with the switch in the open position.



* Front vertical upward switch terminal A



* Front vertical downward switch terminal K



* Rear vertical upward switch terminal F



* Rear vertical downward switch terminal J



* Horizontal forward switch terminal D



* Horizontal rearward switch terminal C



* Recline forward switch terminal H



* Recline rearward switch terminal G



锟斤拷 If not the specified value, replace the seat adjuster switch.



3. Test for less than 1 ohm between each seat direction signal terminal listed below and the B+ terminal E with the switch in the closed position.



* Front vertical upward switch terminal A



* Front vertical downward switch terminal K



* Rear vertical upward switch terminal F



* Rear vertical downward switch terminal J



* Horizontal forward switch terminal D



* Horizontal rearward switch terminal C



* Recline forward switch terminal H



* Recline rearward switch terminal G



锟斤拷 If greater than the specified range, replace the adjuster switch switch.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

No comments:

Post a Comment