Sunday, October 6, 2019

2019 Cadillac Truck Escalade AWD V8-6.2L Diagnostic Instructions Page 710


The voltage on any power rail 2 motor control circuit is below 1.47 V for 100 ms.



Action Taken When the DTC Sets



The MSM will not allow operation of any motor on the power rail for which the DTC was set.



Conditions for Clearing the DTC



* The current DTC clears when the malfunction is no longer present and the power mode changes to OFF then back to ACC or RUN.



* A history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.



Reference Information



Schematic Reference



* Driver Seat Schematics ()



* Passenger Seat Schematics ()



* Adjustable Pedal Schematics (See: Accessories and Optional Equipment/Pedal Positioning System/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Memory Seats Description and Operation ()



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



B3920 01 or B3920 02



1. Ignition OFF, disconnect the X1 harness connector at the MSM.



2. Ignition ON, verify that a test lamp does not illuminate between the control circuits listed below and ground:



* Front vertical motor terminal 12



* Front vertical motor terminal 13



* Rear vertical motor terminal 15



* Rear vertical motor terminal 16



* Seat horizontal motor terminal 9



* Seat horizontal motor terminal 10



锟斤拷 If the test lamp illuminates, test the control circuit for a short to voltage.



3. Test for infinite resistance between the control circuits listed below and ground:



* Front vertical motor terminal 12



* Front vertical motor terminal 13



* Rear vertical motor terminal 15



* Rear vertical motor terminal 16



* Seat horizontal motor terminal 9



* Seat horizontal motor terminal 10



锟斤拷 If not the specified value, test the control circuit for a short to ground.



4. Ignition OFF, disconnect the X4 harness connector at the MSM.



5. Ignition ON, verify that a test lamp does not illuminate between the control circuits listed below and ground:



* Lumbar horizontal motor terminal 12

No comments:

Post a Comment